Wi-Fi

If you want to use your router as a Wi-Fi access point, enable Wi-Fi here and fill in an SSID (the name of the access point) and a corresponding password. You can then set up your mobile devices, using the QR code available within the form.


Wi-Fi settings

Hint: If set, network is not visible when scanning for available networks.
Hint: The 2.4 GHz band is more widely supported by clients, but tends to have more interference. The 5 GHz band is a newer standard and may not be supported by all your devices. It usually has less interference, but the signal does not carry so well indoors.

If you want to use this card for 2.4GHz bands, correction of cables connected to diplexers is needed! Factory default setting: Cables from big card connected to 5GHz, cables from small card connected to 2.4GHz diplexer part.

Hint: Change this to adjust 802.11n/ac mode of operation. 802.11n with 40 MHz wide channels can yield higher throughput but can cause more interference in the network. If you don't know what to choose, use the default option with 20 MHz wide channel.
Hint: WPA2 pre-shared key, that is required to connect to the network. Minimum length is 8 characters.
QR code
Hint: Enables Wi-Fi for guests, which is separated from LAN network. Devices connected to this network are allowed to access the internet, but aren't allowed to access other devices and the configuration interface of the router. Parameters of the guest network can be set in the Guest network tab.

      Hint: If set, network is not visible when scanning for available networks.
      Hint: The 2.4 GHz band is more widely supported by clients, but tends to have more interference. The 5 GHz band is a newer standard and may not be supported by all your devices. It usually has less interference, but the signal does not carry so well indoors.
      Hint: Change this to adjust 802.11n/ac mode of operation. 802.11n with 40 MHz wide channels can yield higher throughput but can cause more interference in the network. If you don't know what to choose, use the default option with 20 MHz wide channel.
      Hint: WPA2 pre-shared key, that is required to connect to the network. Minimum length is 8 characters.
          QR code
          Hint: Enables Wi-Fi for guests, which is separated from LAN network. Devices connected to this network are allowed to access the internet, but aren't allowed to access other devices and the configuration interface of the router. Parameters of the guest network can be set in the LAN tab.
          Discard changes

          If a number of wireless cards doesn't match, you may try to reset the Wi-Fi settings. Note that this will remove the current Wi-Fi configuration and restore the default values.